Yuma Roof Pros provides professional chimney & wall flashing in Yuma, AZ for residential and commercial properties across the lower Colorado River valley. Most of what people here call a chimney is not one. It is a framed and stuccoed chase wrapped around the metal flue of a gas fireplace, and in a good number of Yuma houses nobody has lit that fireplace in fifteen years.
That matters, because a chase is expensive to maintain and cheap to delete. It contributes a cap, four wall-to-roof intersections, a cricket on its uphill side and a run of counterflashing, all of which are joints on a clock. Removing the chase entirely, framing the roof plane flat through where it stood and roofing over it eliminates every one of those permanently.
So we quote it both ways. Reflash and recap, with a number and an expected service life, against remove and roof over, with its own number. Removal is very often the cheaper of the two once a chase is old enough to need a new cap and new flashings in the same year, and it is always the cheaper one measured across the next twenty.
When the chimney is real, or when the fireplace is genuinely used, we flash it properly. Individual step pieces laced in with the courses up either cheek rather than one long bent strip, an apron across the downhill face, a saddle behind anything wide enough to hold water back, and two-piece counterflashing whose upper leg goes into a reglet cut in the stucco or mortar instead of being sealed to its face.
The chase cap is where we see the most failures and the least attention. A flat sheet-metal cap with no slope and a soldered seam in the middle will pond, work its seam open and drain straight into the framing. We build them sloped, cross-broken, in a heavier gauge, with a hemmed drip that stands off the stucco and no fastener anywhere on the top surface.
Wall terminations elsewhere on the roof get the same discipline, particularly the kickout at the bottom of every roof-to-wall run. A missing kickout sends the entire length of that wall's runoff behind the stucco instead of out onto the roof, and it is the single most damaging two-dollar omission in residential roofing. We add one wherever a roof edge dies into a wall, leak or no leak, because the piece costs almost nothing while we are up there.
Our licensed and insured team brings the right materials and equipment to every job — concealed-clip standing seam in 24-gauge Galvalume, bonded washers on exposed panel screws, high-temperature-rated synthetic underlayment, welded inside and outside corners on curb wraps, eave closures and bird stops that pass water rather than dam it, one-piece deck-mounted flashing on tubular daylight units — and backs the work with a written workmanship warranty. We serve Yuma and nearby communities including San Luis, Somerton, Fortuna Foothills, Wellton.
What We Handle
Everything our chimney & wall flashing in Yuma covers
One crew, one point of contact, and the full range of chimney & wall flashing work in Yuma, AZ. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing repair Yuma
- chase cap replacement
- wall flashing roof repair
- counterflashing repair AZ
- step flashing repair Yuma
- fireplace chase leak
- chimney cricket install
- stucco wall to roof flashing
- kickout flashing repair
- chimney chase removal
- roof to wall termination
- flashing leak repair Yuma
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Yuma services.
Materials, equipment and how we do chimney & wall flashing
The difference between chimney & wall flashing that lasts and chimney & wall flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with concealed-clip standing seam in 24-gauge Galvalume, bonded washers on exposed panel screws, high-temperature-rated synthetic underlayment, welded inside and outside corners on curb wraps, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Yuma job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the lower Colorado River valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney & wall flashing outside Yuma
Yuma Roof Pros covers Yuma and the surrounding communities of the lower Colorado River valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney & Wall Flashing in San Luis, AZ — Yuma County, population 35,257
- Chimney & Wall Flashing in Somerton, AZ — Yuma County, population 14,197
- Chimney & Wall Flashing in Fortuna Foothills, AZ — Yuma County, population 27,776
- Chimney & Wall Flashing in Wellton, AZ — Yuma County, population 2,375
- Chimney & Wall Flashing in Gadsden, AZ — Yuma County, population 571
- Chimney & Wall Flashing in Avenue B and C, AZ — Yuma County, population 4,101
Start on the Yuma Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Yuma Chooses Yuma Roof Pros
- ✓Every inspection ends with a numbered count of the penetrations, laps and terminations on your roof, and a service life written beside each one
- ✓Removing an abandoned fireplace chase is priced against reflashing it, because deleting four joints permanently beats sealing them again
- ✓Exposed-fastener metal is not something we will warranty over a finished ceiling, and we explain the gasket arithmetic before you choose
- ✓Leak calls start with a zoned hose test rather than a guess, so you pay to fix the joint that is actually failing
The standards behind chimney & wall flashing
Quality here is not a matter of opinion — it is written down. The chimney & wall flashing work we do in Yuma follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney & wall flashing project in Yuma gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney & wall flashing free estimate in Yuma, or request a quote and we'll get right back to you.